Whites DXF Manuel d'utilisateur télécharger pdf (Page 27)

Chapter 5 DFX

™

Pro Options

1. Ratchet Pinpointing

Pinpointing feature, automatically detunes for easy

target-center locating.

ON - Automatically aids in pinpointing. When the

TRIGGER is squeezed and held for pinpointing,

RATCHET PINPOINTING will shrink the size of

the signal as the loop is passed over the target area

several times. The signal will not fade completely

unless the loop is moved too far away from the

target center.

OFF - When OFF, the signal will remain original

size giving some indication of its size and shape.

Manual shrinking is completed by squeezing and

releasing the TRIGGER several times as the loop

is passed over the target. Manual shrinking can

completely eliminate the target. If the target no

longer responds after manual shrinking, move the

loop away from the target, squeeze and release the

TRIGGER, and again sweep the loop over the area.

If the target is a metal, it should again respond.

Tips -

Use the ON set-

ting until experienced at

pinpointing.

(Audio section)

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 59 60

Pas de commentaire

Whites DXF Manuel d'utilisateur Page 27