Whites DXF Manuel d'utilisateur Page 7
- Page / 60
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
7
Chapter 2 DFX™ Batteries
Battery Life & Memory
Volatile memory
temporarily holds any program
changes or settings not yet saved in a Custom Pro-
gram.
Short-term
or volatile memory is retained so
long as a good battery remains in the detector. To
recover volatile memory immediately squeeze and
release the TRIGGER once the detector is turned
ON. If the battery is removed all volatile memory
is lost.
Long-term
memory (programs saved in
Custom Programs) is automatically saved for up to
ten years regardless of whether a battery is in the
detector or not.
When using fresh batteries, the voltage will initially
check somewhere in the 10 to 14 volt area. Unlike
standard batteries, the rechargeable battery voltage
will quickly drop to between 9 and 10 volts and
plateau there for most of its life. Once the recharge-
able battery voltage drops below this plateau, it will
quickly drop below a usable voltage level (eight
volts) and thus require a recharge.
Low Battery
will
automatically appear on the display when the bat-
tery reaches eight volts.
Like a personal computer, there are times (such as
low battery conditions) when the microprocessor of
a metal detector becomes out of sequence with the
rest of the circuitry. This is often noted by peculiari-
ties in the nondiscrimination or pinpointing (TRIG-
GER squeezed) modes. Symptoms may be blaring
or silent non-discriminate or pinpoint modes, depth
indication inaccuracies or general abnormal opera-
tion. To correct such diffi culties "re-boot" by:
1. Install a good battery.
2. Turn ON wait for MAIN MENU to appear.
3. Open battery door and remove battery while
detector is still ON.
4. Wait one minute, reinstall battery, turn
detector ON, and check for proper function.
Use of maximum backlight may reduce battery life
by up to 50%, depending on battery type.
Rechargeable batteries gradually deteriorate. As
they age they do not provide the life-per-charge
they did when new. This is expected, and not
grounds for replacement under warranty. Addition-
ally, a damaged initial cell, which is caused by over-
charging with the QUICK option,
is not replaced
under warranty
. Only cell failure through normal
use, or a defect due to a problem with a White's
warranted DFX
™
charger, is covered.
- Contents 1
- Assembly 2
- Assembly Instructions 3
- Batteries 4
- Rechargeable Battery 5
- Using the 5
- Standard Battery Holder 5
- Charging 6
- Battery Life & Memory 7
- Search Fundamentals 9
- Why Air/Ground Balance? 9
- Chapter 3 DFX 10
- Quick Start 10
- Live Search Screen Samples 11
- Pinpointing the Target 12
- Ready to Dig 13
- Factory Preset Programs 13
- Basic Adjustments 14
- "Hot Key" Shortcuts 15
- More Basics 15
- Chapter 4 DFX 16
- Basic Adjustments 16
- Other Custom EEPROM 17
- Program Info 17
- 1. Target Volume 48 - 63 18
- 2. Audio Threshold 18
- 3. Tone (Audio Frequency) 19
- 4. Audio Disc 19
- 5. Silent Search 20
- 6. Mixed Mode 21
- 7. A.C. Sensitivity 22
- 8. D.C. Sensitivity 22
- 9. Backlight 23
- 10. Viewing Angle 24
- Pro Options 25
- 1. Ratchet Pinpointing 27
- 2. S.A.T. Speed 28
- 3. Tone I.D 29
- 4. V.C.O 29
- 5. Modulation 30
- 6. AutoTrac 31
- 7. Trac View 31
- 8. Trac Speed 32
- 9. Trac Offset 33
- 10. Trac Inhibit 33
- 11. Coarse G.E.B 34
- 12. Fine G.E.B 35
- 13. Disc. Edit 36
- Chapter 5 DFX 37
- Pro Options 37
- 14. BLOCK Edit 38
- 15-16. Learn Accept/Reject 39
- 17. Recovery Speed 40
- 18. Bottlecap Reject 41
- 19. Hot Rock Reject 42
- 20. Sweep Speed 43
- 21. Ground Filtering 44
- (High Pass Filters or 44
- Differentiators) 44
- 22. Visual Disc 45
- 23. Icons 45
- 24. V.D.I. Sensitivity 46
- 25. D.C. Phase 47
- 26. Accumulate 48
- 27. Average 48
- 28. Fade 49
- 29. Preamp Gain 50
- 30. 2 Frequency (Best Data) 51
- 31. 2 Frequency (Correlate) 51
- Multi Frequency Method 51
- 32. V.D.I. Normalization 52
- 33. 1 Frequency (3 kHz) 52
- 34. 1 Frequency (15 kHz) 52
- Factory Pre-Loaded Custom 53
- EEPROM Programs 53
- Pre-Loaded EEPROM Programs 54
- Preset Program Settings 55
- Glossary 57
- WARRANTY TRANSFER 58
- LIMITED WARRANTY STATEMENT 59
- White's Service Centers 60
Produits connexes et manuels pour Mesure, test et contrôle Whites DXF
(58 pages)
(24 pages)
(7 pages)
(13 pages)Sony STR-DE185 manuály
Uživatelské manuály a uživatelské příručky pro Přijímače a zesilovače Sony STR-DE185.
Poskytujeme 1 manuály pdf Sony STR-DE185 ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Commentaires sur ces manuels