Whites V3 Manuel d'utilisateur télécharger pdf (Page 9)

For best results, instrument start up should be followed by a manual ground balance.

Pull and hold trigger, then press and hold enter while pumping loop up and down

over the ground until threshold is smooth. Release enter then release trigger. Also

helpful as an option to check tracking from any search mode.

Report - ON (“X” in box) Activates ground tracking indicator arrows on display reports

(indicates) the automatic increasing or decreasing of the ground balance point.

Inhibit - ON (“X” in box) When on, delays the point automatic tracking begins to

adjust to the ground. Helps in iron infested ground. Use off in widely variable ground

with little or no iron to allow immediate tracking.

Speed - Adjust the rate of ground tracking – higher numbers “track” faster to changes

in the ground.

Offset - Manually moves ground balance point from perfect balance. Positive offset

often used in highly mineralized ground to enhance low conductive and small (gold,

silver, coins) targets in radically changing noisy ground.

Locktrac - Locks ground setting. Turns off all tracking. Turn ON and use manual

method above. Best used for repeatable responses on very deep targets, and rejec-

tion of difcult minerals.

LIVE CONTROLS - GROUND BALANCE/TRACKING

Ground Balance/Tracking

Ground Balance/Tracking Zoomed

Ground Balance/

Tracking

Ground Probe -

Provides helpful information -

• To determine the severity of ground

(weak ground vs strong ground).

• Targets can also be analyzed for VDI

number, phase and target strength at

each frequency. To use - (from Zoomed

Live Control) Menu/Tab to Zero and press

Enter with loop in air. Hold loop on the

ground or target to read results.

Pas de commentaire

Whites V3 Manuel d'utilisateur Page 9